How To Carve A Bat Pumpkin Lantern
How to carve a bad pumpkin lantern: Learn how to carve a pumpkin the VideoJug way! The lit bat in the belfry pumpkin will look the most effective when placed in the dark, so carve A Bat Pumpkin Lantern today!
Step 1: You will Need
- A pumpkin
- A pencil
- Some adhesive tape
- A bowl
- A little flour
- A scoop or a spoon
- A small drill tool
- A pointer or sharp tool to make holes in the pumpkin
- And a small saw or a thin serrated knife
- A tea light - to bring the finished pumpkin lantern to life
- You will also need a template
Step 2: The lid
Draw a keyhole shape around the top of the pumpkin. This will create the lid so needs to be large enough to fit your hand through. The keyhole shape makes replacing the lid easy, ensuring you always get a good fit. Draw the shape using straight lines, this will be easier to cut around than a curved ones.
Use a saw tool, or a serrated knife to cut around the line. Angle the knife in towards the centre of the pumpkin rather than straight down, this will prevent the lid from collapsing into the finished pumpkin. When you have cut all around the line, lift the lid. Slice off any stringy pieces from it's underside into a bowl.
Step 3: Get scooping
Remove any seeds and pulp from the inside with the scoop or a spoon. Have a bowl ready to put the mush in or it can get messy! Keep scooping, scraping away the inside flesh until the wall of the pumpkin is about 3 centimeters thick all around.
Step 4: The template
Cut from the point of each corner in towards the center, just a couple of centimeters. This will help it bend to fit to the rounded pumpkin shape. Use adhesive tape to place it in position. Then carefully smooth the template over the pumpkins, tucking and folding the outer edges until the template fits. Use more tape to hold it in place
Step 5: Mark the design
Use a pointer or a similar sharp tool to prick holes around the black areas. These can be a couple of centimeters apart in straight lines but must be closer together on the more intricate parts of the design. When you have outlined the entire pattern with holes remove the bat template. Keep it nearby to check the pattern as you carve
If the holes are difficult to see rub a little flour in to highlight them.
Step 6: Join the dots
With a back and forth motion, use a small saw or a serrated knife to join the dots. Always remove the smaller areas first. Start on the eye and wing shapes. Then move onto the belfry.
When you are happy with the details carve around the larger pieces. Be gentle and take your time, removing the unwanted pumpkin as you go. Don't try and slice your way through the flesh, stick to the sawing motion. Keep following the dotted outline until you have carved the entire design. Once all the pieces have been removed the bat and belfry will be easy to see
Step 7: Light up
Light the tea light, place it at the bottom of the pumpkin and put the lid on. Always use a tea light in a pumpkin, a regular candle will burn too quickly and won't stay upright.
The lit bat in the belfry pumpkin will look the most effective when placed in the dark. Have a look a VideoJug's 'How to trick or treat' to make sure you are thoroughly prepared for Halloween.