How To Install A Battery In Your Palmone Lifedrive

Step 1: You will need:

For this installation, you will need a T5 Torx driver, a scratch-resistant shin tool and a new battery from ipods99.com. Let us begin by removing the two grey pieces of rubber covering the screws. Using the T5 Torx driver, remove the screws on the back of your Palm.

Step 2: Pry apart case:

Now, use your shin tool to pry apart the case. There are two indented on each side of the case seam. These are clips that can be released by pushing inward while prying. Lift the back cover straight off. Unscrew bald internal screws.

Step 3: Lift internal shell:

Cautiously lift the internal shell to the side. Be careful not to put strain on the connected speaker wire.

Step 4: Replace battery:

Detach the existing battery from the motherboard. Plug your brand new battery from ipods99.com into the motherboard with the ridged edge of the connector facing up. Gently replace the internal shell.

Step 5: Reassemble drive:

Screw the shorter Torx screws back into place. Put the back cover of your LifeDrive back on, fastening the clips. Replace the last two screws. Finally, replace the rubber covers.

Step 6: Charge new battery:

We recommend that you charge your new battery from ipods99.com for at least three hours before using.