Videojug

How To Install A Rear Facing Newborn Child Car Seat

Print Info
  • Videojug
  • Videojug
  • 3:6
  • Yes
  • 360p
  • 640x360
  • Flash
  • h.264
  • 900kbps

How To Install A Rear Facing Newborn Child Car Seat

A poorly installed car seat can be a danger to your child, so learn how to install a rear facing newborn child car seat properly with help and advice from VideoJug. A poorly installed car seat can be a danger to your child, so learn how to install a rear facing newborn child car seat properly with help and advice from VideoJug.

Rear facing car seat

Step 1: Install The Base

These should only be installed in the back seat. Install the base. Thread seatbelt thorugh the base, as outlined in owner's manual.

Step 2: Tighten

Kneel directly on the base and fasten the seatbelt to get a tight fit.

Step 3: Snap Into Base

Snap the car seat into the base. Wiggle back and forth. There should be less than an inch of wiggle.

Step 4: Check The Angle

Make sure the seat is installed at the proper incline. An angle of 45 degrees is typically recommended.

26,703 views
Tips & Comments
  1. Anonymous

    I had installed mine and it was wrong. So I went to the State Police Barracks and they put it in for me too.. Wonderful idea. Thanks, Glenna Pritchard

  2. Anonymous

    Go to you local State Police and Let them check it for free also.. It will make you feel much safer..

  3. Anonymous

    should check the State Child Restraint Requirement before buying the car seat: http://www.childseatcenter.com/article10.html