How To Put Foam Curlers In Hair
In this video, it is shown how to put foam rollers in your hair. It's a good way to get a new look which can be tried at home if you have rollers with you. Just remember that the hair must be washed properly and dried before starting.
I am going to show you how to put foam curlers into your hair. As you can see, I already have four rollers put in and it is simple to put the hair first, so wash the hair and roughly dry with the hair dryer so that the hair is about 75% dried off. You just want to leave it slightly damp.
If you have the hair too wet, then it will take days to dry, so you want to let the hair dry in about 2 hours or few hours, 3 or 4 hours, if you are not using heat. So, make sure the hair is a little damp and set the hair with the setting lotion or apply gel or cream something. So, take a section about an inch and half, 2 inches wide, about a centimeter and half deep, just comb the hair through, making sure you got no split ends or knots.
Keep in the hair up this angle when you're following the head shape round, when it comes to back pulling out this angle, keeping the attention and foam roller. You get all the different sizes of rollers, so you can get much more natural curl. Halfway, wind the hair around the roller and keep it wet at the end.
Twist the roller down. You need to little tuck and it will end half the way, so it will be nice and tight. Once it is nice and tight, you fold the roller like to the side.
After you completed whole of the head, you then can either use heat diffuse, a hair dryer, for about 15 to 20 minutes, and you can test your hair and see how the side looks, so I will just unravel and you can just feel with your fingers whether it's still damp. If it is slightly damp, then just pop the roller back in and nice and tight, just keep going with your hair dryer and diffuse until the whole head is dry. If you want to use the foam rollers without any heat, then you probably need to blow up to 3 or 4 hours drying time.
It is really important that the hair is not damp, so when you roll it out, it has to burn dry, so if there is any damp, then the curls will just drop and remove very quickly. Once it is finished, take all the rollers out and you can just gently comb the curls with the fingers or wide-tooth comb which does not disturb the curls and little bit of hairspray and finish the look. That is how to put foam rollers into your hair. .