How To Replace Your Garmin Street Pilot C330 Battery
From NewPower99.com, this video provides a step by step demonstration of the procedure for replacing the battery in your Garmin Street Pilot c330. The battery, along with the necessary installation tools shown in the video, can be found at: http://www.newpower99.com/Battery_for_Garmin_StreetPilot_c330_p/garmin%20streetpilot%20c330.htm
Step 1: Opening the Garmin StreetPilot c330
Begin by using the plastic shim too to remove the silver colored front faceplate.. Then remove the revealed four screws using the Phillips screwdriver provided in your kit from NewPower99.com . Open the case and unplug the existing battery’s connector. Be sure to observe and make note of the positioning of the wires.
Step 2: Removing the Original Garmin Street Pilot c330 Battery
Remove the two screws securing the original battery. Use a soldering iron to carefully detach the 4 wires connecting the original battery to the Garmin. Remove the battery.
Step 3: Install the Replacement Battery in the Garmin StreetPilot c330
Insert the extended life battery from Newpower99.com in the same position and orientation as the removed battery was found. Replace the 2 screws to secure the battery to the Garmin. Solder the leads to the Garmin in the same positions as the original.
Step 4: Closing the Garmin StreetPilot c330
Replace the plug into the connector on the unit and gently close the case. Replace the 4 screws on the front of the unit and snap on the front cover plate.
Step 5: Finish the Garmin StreetPilot c330 Battery Replacement
Charge the unit for at least two hours. Turn unit on. It should work perfectly.